String Height at the 1st Fret
| Low Action | “Normal” Action |
|---|---|
| Low E: 0.51mm (0.020”) High E: 0.30mm (0.012”) | Low E: 0.76mm (0.030”) High E: 0.41mm (0.016”) |
Beside above, how close should bass Pickups be to strings?
Fender recommends 2mm space between the underside of the string and the polepiece for the treble- and 2.8mm space for the bass side for J- and P-basses.
In this way, how do I know if my action is too high? If your guitar’s intonation is out or the guitar feels awkward to play compared to other guitars, the action may be too high. High action can throw off your guitar’s intonation because you need to push the string further to reach the fret. The distance you push the string causes the note to bend out-of-tune.
Additionally, how do I know if my guitar nut is too high?
To check nut-slot height, hold the string down at the third fret, and see how much it moves over the first fret. This is similar to checking neck relief, but the string should move much less. If the string doesn’t move at all, chances are the slot is too low.
How do you get bass strings closer to fretboard?
How far should bass strings be off the fretboard?
Measuring at the 12th fret (as in the photo), the action height should be 2.6 mm for Steel String Acoustic guitar, 1.8 for electric, 2.0mm for bass and 3mm for a Classical.
How far should the strings be from the fretboard?
If it’s hard to push down the strings onto the neck, your strings may be too far from the frets. The “action” or distance between the strings and the neck differs among guitar players, but 1.6 mm (0.063 in) is standard for most guitar players.
How high should bass frets be?
A good bass setup is all about compromise, and as a guitar technician, you always have to find the best balance between playability and the most amount of fret buzz that you’re willing to tolerate. Some common action measurements on a bass guitar are around 5/64″ up to about 7/64″.
How high should bass strings be?
You can also use a capo to hold the strings down at the 1st fret. Generally, the lowest string (E string in standard tuning) should be at 6⁄64 inch (2.4 mm) and the highest string (G string in standard tuning) should be at 5⁄64 inch (2.0 mm).
How much clearance do you need for first fret?
Check The String Height At The 1st Fret
Again, using the feeler gauge, measure the gap between the top of the 1st fret and the bottom of the 6th string; the gap should be . 022″ +/- . 002″.
What is considered low action?
If so then in my opinion, something around 1.5 mm (= 1/16″, = 4/64″) is generally considered “low”. Now with a poorly set up nut and poorly set neck relief, this sort of action can be both buzzy up the neck and miserably difficult to play in positions near the nut.
What should be the guitar action at first fret?
Assuming the neck is straight (no relief) and the nut is set at fret height, then the first fret action is always 11.22% of the 12th fret action. For example, a 12th fret action of 0.095″ should result in a first fret action of 0.095″ times 0.1122, or 0.011″.