The slots should be only deep enough so 1/3 of the string is above the top of the nut and 2/3 in the nut.
Moreover, how do I know if my guitar nut is too low?
To check nut-slot height, hold the string down at the third fret, and see how much it moves over the first fret. This is similar to checking neck relief, but the string should move much less. If the string doesn’t move at all, chances are the slot is too low.
Also know, how do you build a guitar nut slot?
Keeping this in consideration, how do you fix a low nut slot?
How do you measure the depth of a nut slot?
You can measure the nut slot heights by placing a feeler gauge in between the bottom of the string and the top of the first fret when the guitar is up to pitch and after the neck and bridge are adjusted.
How far should the strings be from the fretboard?
If it’s hard to push down the strings onto the neck, your strings may be too far from the frets. The “action” or distance between the strings and the neck differs among guitar players, but 1.6 mm (0.063 in) is standard for most guitar players.
How high should strings be off first fret?
String Height at the 1st Fret
| Low Action | “Normal” Action |
|---|---|
| Low E: 0.51mm (0.020”) High E: 0.30mm (0.012”) | Low E: 0.76mm (0.030”) High E: 0.41mm (0.016”) |
How high should the nut be on a guitar?
The top of the nut is shaped to follow the radius of the fretboard, and the string slots also follow this curve. To allow the strings to clear the top of the first fret, the bottoms of the slots should be . 030″ higher than the fret height.
How is guitar nut slot height measured?
How Should guitar strings sit in the nut?
Nut Slots: Depth
Big deep slots and a quarter-inch of nut above the strings just looks a bit rubbish. Ideally, your wound strings should have about half to two-thirds of their diameter in their slots and the unwound strings should sit just below the surface.
How wide should nut slots be?
In making an ideal nut you will want the actual width of the nut slot to match the width of the string exactly. A string whose width is . 017”, or seventeen thousandths of an inch, wants to sit in a slot that is exactly seventeen thousandths of an inch.
Should I glue the nut on my guitar?
Is it necessary to glue a guitar nut in place? Gluing the nut is not completely necessary, the pressure of the strings and the friction between the nut and neck will hold it in place. However, you can use a few drops of white wood glue to fix it in place to prevent it falling off when changing strings.
What is the distance from the nut to the bridge on a guitar?
On pretty much every guitar the bridge should be located so that the break point of the string will be exactly at the distance of the scale length, from the nut. The scale length of any guitar is defined as double the distance from the nut to the 12th fret.
Why do I get fret buzz?
There you have it. Three common causes for fret buzz: (1) uneven frets (2) excessively low string action, and (3) a back bowed neck. Just one of these problems is enough to cause fret buzz, but often times a guitar has a combination of these three problems all at once.