Can you put a noise gate after a compressor?

Putting a noise gate after the compressor will clean up the hiss but it will not remove mistakes that your playing is introducing. It will also clamp some of the notes, and depending on your settings and the quality of the gate this can mess with your tone.

>> Click to read more <<

Beside this, how do you use a noise gate?

How-to Use a Noise Gate in 8 Steps

  1. Step 1: Patch your gate inline. Patch inline. …
  2. Step 2: Set Everything at Minimum and Threshold at Maximum. …
  3. Step 3: Slowly Lower the Threshold. …
  4. Step 4: Find your Sound. …
  5. Step 5: Set the Attack. …
  6. Step 6: Set the Hold. …
  7. Step 7: Set the Release. …
  8. Step 8: Adjust the Floor.

Likewise, should a compressor go before or after overdrive? By putting the compressor after the overdrive, any top-end transients or low-end boominess gets compressed, giving an even response. With this signal chain, make sure that the overdrive pedal’s output is set to unity gain to keep the compressor from over-squashing.

Keeping this in consideration, should you compress before EQ?

Each position, EQ pre (before) or EQ post (after) compression produces a distinctly different sound, a different tonal quality, and coloration. As a rule, using EQ in front of your compressor produces a warmer, rounder tone, while using EQ after your compressor produces a cleaner, clearer sound.

What comes first noise gate or compressor?

Sometimes you can remedy this by placing a noise gate before the compressor, however, the noise reduction can have an effect on the tone quality. A best-of-both-worlds approach might be to put your compressor first and use a signal booster just before your amplifier.

What is a noise gate pedal?

Noise Gate Pedals are an essential component of any pedal board. They eliminate any unwanted noise such as single coil pickup hum or high signal gain from your setup, allowing you to take full control over your sound.

What is gate and compression?

Where do you put the noise gate?

Where does a noise gate go in your signal chain? In some ways, this is subjective. Naturally, you’ll want to place the noise gate wherever the noise is, for example after your fuzz pedal. It’s most common, however, to put it at the end of your chain but before any ambient pedals such as delay and reverb.

Where should a compressor go on a pedalboard?

The Official Textbook of Pedal Placement™ states that, apart from vintage fuzz and wah, compression should always be first in the chain.

Where should noise gate go in vocal chain?

Will a noise gate stop 60 cycle hum?

The noise gate will only kill the hum whilst you are not playing of course – as soon as you hit a note, the note comes through but so does the hum. I’ve only ever had one set of noiseless pickups which were in a Telecaster – they were OK but (from a sound perspective) I preferred the more traditional ones I put in.

Will a noise gate stop feedback?

There are also devices that can be purchased that could stop your feedback from occurring while jamming out. One of these devices is a noise gate, which is a device that controls audio signal volume and, in turn, could end up stopping feedback.

Leave a Comment