Subsequently, do you need sanding sealer?
Michael Dresdner: “Sanding sealer is never mandatory. It is an option that saves time and material in some situations, and is unnecessary in others. Some woods, like cedar, spruce, and poplar, are so porous that they tend to suck up the first few coats of sprayed lacquer as if nothing were applied.
Beside this, do you sand after grain filler?
Hereof, do you stain before grain filler?
The best practice, therefore, especially with oil-based grain filler, is to stain the wood, apply a washcoat, then apply the grain filler. Here are the reasons: You’ll get better contrast between the pores and the wood, which will create more depth.
Does swamp ash need a finish?
Re: Finishing Swamp Ash
Ash is a very open pored wood which is why it’s grain filled normally. Without doing so any finish applied will soak in and in.
Does swamp ash need grain filler?
A bit of work early on saves a lot of work later. Open-pored woods such as ash must be grain filled before lacquer is applied otherwise the lacquer will sink into the grain and it will be very difficult and expensive in lacquer to get a smooth finish.
How do you seal ash wood?
How to Finish Ash Wood
- Sand with heavy grit first. Start with 120 grit. …
- As the finish smooths out, increase the grit of the sandpaper. …
- Apply sanding sealer. …
- Apply stain. …
- Apply pore filler. …
- Remove excess pore filler.
Is swamp ash a heavy wood?
The term “Swamp Ash” does not refer to any particular species of ash (Fraxinus genus), but is generally used by luthiers to describe lightweight wood yielded from ash trees which are usually found in wet or swampy areas.
Is swamp ash good for guitars?
Swamp Ash is not used for necks, fingerboards, or for acoustics guitars. Visually: Ash can produce some striking grain patterns or it can be very straight grained and pretty plain. The Swamp Ash is known for producing more interesting patterns such as Cathedral’s, Arches, Oval’s, and Ellipses.
What is the difference between swamp ash and ash?
Swamp ash in particular is lighter than its relative Northern Ash and has larger, open pores. It produces chiming highs, clear midrange and strong low end that lets higher overtones ring through, resulting in greater harmonic content.
Why did Fender stop using ash?
In an interview with Guitar World, Fender’s Executive Vice President of Product, Justin Norvell, revealed that the difficult decision was made largely because of the Emerald Ash Borer beetle, a non-native invasive pest that has been destroying the unique “swamp ash” found in the American South – favored by Fender for …
Will shellac fill wood grain?
Shellac will even work to completely fill the grain on highly porous woods like oak and ash.