With the compressor placed before the overdrive pedal, the compressor will give you a relatively even output level, causing the overdrive pedal to produce a very consistent distortion or drive amount.
Also know, do bassists need a compressor?
Bass Compression
A bass compressor is about the only must-have effect for bassists regardless of the style you play. I highly recommend getting a compressor both for live playing and home recording. The average listener won’t know it’s there, but you will enjoy the subtle effects.
In this manner, does reverb come before compression? Over time, producers have discovered that you get a better sound if you put reverb towards the end of the signal chain, after EQ and compression.
Just so, how do I set my guitar compressor pedal?
Should a compressor go in the effects loop?
Here are some common effect placement suggestions for pedalboard setups in general. Dynamics (compressors), filters (wah), pitch shifters, and Volume pedals typically go at the beginning of the signal chain. Gain based effects such as and overdrive/distortion pedals come next.
Should compressor go before or after wah?
In a pedalboard, the compressor unit generally goes after a wah pedal. While it is of course a matter of preference, putting the compressor first will limit the range, function, and dynamics of the wah pedal. The result will be arguably less musical and pleasing overall.
Should you compress before EQ?
Each position, EQ pre (before) or EQ post (after) compression produces a distinctly different sound, a different tonal quality, and coloration. As a rule, using EQ in front of your compressor produces a warmer, rounder tone, while using EQ after your compressor produces a cleaner, clearer sound.
When should you use a compressor pedal?
A compressor pedal is a stompbox pedal that sits in your signal chain and levels the dynamics of your guitar performance. When you play something very quietly, a compressor can boost the output to make it more audible.
Where do you put a compression sustainer?
A good rule of thumb is to place any gain-type effects before modulation effects: i.e., compressors and overdrives before delays or flangers. Another one that’s practically set in concrete is to put the compressor before any overdrive, distortion, or fuzz pedal.
Where do you use a compressor?
Compression is used to reduce the dynamic range of an audio signal. A compressor is like an automatic volume knob that turns down an audio signal’s level when it gets too loud.
Where does the bass compressor go in pedal chain?
Most bassists put compressors near the end of their signal chain to wrangle the wide scope of frequency their bass sounds can create, and I know that putting a compressor at the end of the chain is great for streamlining your tone and making it easier for the person running sound.
Which comes first noise gate or compressor?
If the noise is not fixable, then put the noise gate right after the bass. If your compressor is noisy (using it with a clean/non-noisy bass, or with nothing plugged into it), then it’s not a good one IMO and you might just replace it.