The Fender spec for most Stratocasters says to set the bridge so that its back is 1/8″ off the top.
People also ask, how do you make a Stratocaster play easier?
5 Quick and Easy Ways to Make Your Cheap Strat Play Better
- Lubricate the Nut. Often on cheap guitars you’ll find the nut that holds the strings is poorly cut or not perfectly sized. …
- Swap Out the Bridge. …
- Swap Out the Tuners. …
- Put on New Strings or Change Them More Often. …
- Adjust the Action or Truss Round.
Moreover, how do you set a Strat saddle? Setting Intonation on a Strat
- Pick the open string and verify it’s in tune.
- Fret at the 12th fret and pick this note. …
- If the 12th fret note is flat, move the saddle forward a little by turning the adjustment screw at the back of the bridge (counter-clockwise).
Then, how do you set up a Stratocaster tremolo?
Allowing the bridge to float freely (no tension on the tremolo arm) using the claw screws in the tremolo cavity, adjust the bridge to your desired angle—Fender spec is a 1/8″ (3.2 mm) gap at rear of bridge. You’ll need to retune periodically to get the right balance between the strings and the springs.
How high should a guitar saddle be?
Before you decide whether or not to make an adjustment you should also consider that your saddle must fit deep and snug in the slot without wiggle room, that the saddle top radius should match that of your fingerboard, and that the desired saddle height should probably not average less than 1/32 inch or more than 3/16 …
How high should electric guitar saddle?
For electric guitars, in our opinion, a good default string height at the 12th fret is typically about 6/64th of an inch (2.38mm) on the bass side and 4/64th of an inch (1.59mm) on the treble side.
How high should my guitar action be?
String Height at the 12th Fret
| Low Action | Medium Action | High Action |
|---|---|---|
| Low E: 2.0mm (0.079”) High E: 1.5mm (0.059”) | Low E: 2.5mm (0.098”) High E: 1.8mm (0.071”) | Low E: 3.8mm+ (0.149”) High E: 3.2mm+ (0.126”) |
How high should the action be at the 12th fret?
Measuring at the 12th fret (as in the photo), the action height should be 2.6 mm for Steel String Acoustic guitar, 1.8 for electric, 2.0mm for bass and 3mm for a Classical.
How high should the action be on a Stratocaster?
ACTION
| Neck Radius | String Height Bass Side | Treble Side |
|---|---|---|
| 7.25″ 9.5″ to 12″ 15″ to 17″ | 5/64″ (2 mm) 4/64″ (1.6 mm) 4/64″ (1.6 mm) | 4/64″ (1.6 mm) 4/64″ (1.6 mm) 3/64″ (1.2 mm) |
What is considered low action?
Most agree that low action occurs when the string height is at, or less than 3/32 inches, on the bass side and 1/16 on the treble.
Why is my tremolo so high?
Typically, the tremolo should look parallel to the body of the guitar if things are setup properly. Either your string gauge is too large, your tuning is too high for string gauge, or the springs on the back of the tremolo are too loose.