Fret leveling normally includes crowning, polishing, and cleaning the fingerboard. Most competent Luthiers will charge you $80-$100. If someone quotes you much less than that, they are probably only doing a quick touch-up leveling, not the whole job.
Furthermore, can you file down guitar frets?
Moreover, how do I level my guitar frets?
Also, how do you get Level 1 frets?
How do you PLEK a guitar?
Standard Plek Pro Setup Includes:
- Setting your truss rod for optimal relief.
- Installing your preferred brand and gauge of strings (strings are purchased separately)
- Scanning your fretboard into the machine.
- Recording the measurements.
- Setting the action to optimum height.
How do you smooth guitar frets?
Using the special three-corner file, place the “toothless” edge facing down toward the fretboard and gently roll the file over the edge of the fret end (Photo 5). It only takes about three or four gentle strokes to smooth out the fret end.
How long does a fret level take?
i.e. change a med/ high fret profile to a wide/ low. This entire process takes me about 4 hrs with short breaks to rest my arm and “get away from it”. I can usually do a full refret (other than maple board) in less time. Keep this in mind if you take your guitar in to have this kind of work done.
How many times can you Refret a guitar?
Typically, you replace your guitar fret bars (refret) after 20-30 years. Whereas you can perform a fret dressing more often – every 3 years or so. Depending on the wear and performance of the guitar.
How much does a guitar fret job cost?
Refretting usually costs between $200 and $400, and it is worth it if you plan on playing that guitar. Especially if it is a more expensive one. Refretting cheaper guitars might not be a good idea since the whole procedure can cost more than you paid for the instrument.
How much does a PLEK job cost?
How Much Does It Cost to PLEK a Guitar? PLEK machines are serious investments, for any luthier or repair shop, coming in at around $250,000 per unit. As such, a shop that goes to this expense will have to charge in order to recoup their investment. Prices vary, of course, but $200 is about average for a PLEK service.
How tall should my frets be?
So, my advice in most circumstances is that a fret height of less than 0.025” (about 0.65mm) is probably the lower limit for the majority of players. Less than this and you’re probably into refret territory.
Is fret leveling necessary?
If your guitar has dead spots, or areas where the buzz is noticeably worse in some areas than others, then you will benefit from a fret level, assuming you have enough height left in the frets to accommodate leveling (more below).
What is crowning a fret?
Fret crowning is the process of using files and other tools to reshape the frets, especially after they have been leveled or dressed by a tech or a partial or total refret has been performed.